Nix Electronic Lice Comb, Detects and Destroys Lice on Contact, Chemical-Free

Warning & Precautions: Nix Electronic Lice Comb should be used on head hair (scalp) only; body and genital lice are not the same as head and scalp lice and require difficult treatments. Do not use this device on pets; pets cannot carry human head lice and should not be treated with this product. Do not use on wet or oily hair. Do not hold metal combs with fingers when the power is switched on. The device is not water proof. Do not immerse it in any liquid. Never place in the mouth or on any other body parts except on head hair. This device should not be operated by or applied to persons with epileptic conditions and/or heart-failure patients. The appliance may disrupt the operation of electronic health devices. Some sensitive persons may feel slight tingling (sometimes this can be caused from perspiration); there is no electric shock risk. Lice Comb should be used on children by adults only. Avoid dropping and other heavy impact on the lice comb.

Nix Electronic Lice Comb: Read these instructions carefully to ensure proper and safe operation of your comb. Directions For Use: For best performance and optimal efficiency of this device, please read and conform strictly to the following instructions: Before Use: 1. Hair must be dry before using this electronic device. This device should not be used simultaneously with any shampoos or other treatments. 2. For best results, hair should be free of styling product, i.e. gels or mouses. 3. Before treatment, comb the hair thoroughly with a regular comb to free all knots. The tines of the lice comb are purposefully very close and may have difficulty combing the hair of the hair has not been previously combed. As with most common lice treatment methods, it is recommended that the treatment be repeated over the course of the egg nit hatching (10 days) to ensure the infestation is full eradicated. For maximum effectiveness, repeat the treatment every 2-3 days for 10 total days. Operating the Lice Comb: 1. This device has a 3-position power switch: OFF - slide all the way back, away from the comb teeth. ON - slide one click forward; green LED power light illuminates. ON with spotlight - slide forward towards the comb teeth; green power light illuminates and bright LED spotlight illuminates. 2. Hold the Nix comb at a 45-degree angle (the ON button is facing up towards the user) and start combing with the comb teeth nearwhat the hair-roots. The spotlight can help see the lice in low light setting oron those persons with dark hair. 3. When the comb has trapped and killed a louse, the red louse detection alert light will illuminate. 4. Stop combing the hair, and remove the louse from the comb teeth. The brush located on the underside of the device can help clean the teeth. 5. After the louse is clear, the light will turn off and the comb is ready for use again. Limitation: Will not operate on wet or excessively oily hair. Cleaning: The metal comb can be cleaned with the included mini brush or may be cleaned with rubbing alcohol if removed from the device housing. To remove the metal combs, remove the plastic housing surrounding the combs. Then gently push the combs through the housing. Wipe the combs with a cloth with rubbing alcohol (70% isopropyl alcohol) and allow to air dry before reassembly. Storage: Store the unit in a secure, dry, dustfree place when not in use. Avoid extreme temperatures. Do not attempt to disassemble the unit. Battery Installation: This device comes complete with 1 AAA battery. 1. Remove the battery cap by carefully titling the cover down and pulling gently. 2. Remove and replace the battery, taking care to note the proper polarity. 3. Replace the battery cover. 4. It is recommended to remove the battery if the unit will not be used for an extended period of time. Always follow local regulations for proper disposal of batteries.