a smart way to save energy

LED technology

long life/low energy

60 watt replacement

11 watts

5 YEAR LIMITED WARRANTY

See back for details.

LASTS 13.7 YEARS*

* Based on 3 hours use per day.

$80 ENERGY SAVINGS Per Bulb**

** Compares one 11 watt LED (800 lumens) which provides nearly the same light output as one 60 watt Incandescent (840 lumens). Electricity cost savings based on using the bulb for 15.000 hr rated life at 11 per kilowatt hour compared to fifteer 60 watt Incandescent bulbs (rated life 1000 hours).

Brightness
800 lumens

Estimated Energy Cost
$1.32 per year

DIMMABLE

Dimming performance may vary.
Go to: www.gelighting.com/dimming for more information.

contains:1 bulb (A19)

fits most standard lighting fixtures

Limited Warranty: Guaranteed to last 5 years based on 3 hours consumer use per day at 120V. If this bulb does not last 5 years, return UPC and register receipt along with your name and address to GE Lighting, Product Service Dept., 1975 Noble Road, Cleveland, OH 44112. GE will replace your bulb. BULB REPLACEMENT IS GE'S SOLE WARRANTY OBLIGATION, AND INCIDENTAL AND CONSEQUENTIAL DAMAGES ARE EXCLUDED. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above exclusion may not apply to you. This warranty gives you specific legal rights and you may also have other rights which vary from location to location.

Lighting Facts Per Bulb

Brightness 800 lumens

Estimated Yearly Energy Cost $1.32
Based on 3 hrs/day, 11c/kWh
Cost depends on rates and use

Life
Based on 3 hrs/day 13.7 years

Light Appearance
Warm Cool
2700 K

Energy Used 11 watts

Manufactured for GE Lighting
General Electric Company
Neal Park
Cleveland, OH 44112
Made in China

C UL US
LISTED

LED LAMP

Visit us on the internet...www.GELighting.com

CAUTION
Risk of Electric Shock - Do not use where directly exposed to water. This device is not intended for use with emergency exit luminaries.

Not for use in totally enclosed recessed luminaries. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the manufacture could void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interface to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: reorient or relocate the receiving antenna, increase the separation between the equipment and receiver, connect the equipment into an outlet on a circuit different from that to which the receiver is connected, or consult the dealer or an experienced radio/TV technician for help.